Plug-and-play Easy Installation

How to mount or hang your sign?

Welcome to your new LED neon sign! To ensure a safe and effective installation, please follow these step-by-step instructions. Before beginning, remember to handle your sign with care to avoid any damage.

Tools needed:

  • Drill
  • Screwdriver
  • Level
  • Pencil (for marking drill positions)
  • Measuring tape

Safety precautions

  • Ensure power is off during installation
  • Avoid touching the LED part of the sign directly
  • Wear safety gloves if necessary

Step 1

Unbox your sign
  • Carefully remove the sign from its packaging.
  • Check for any damage that might have occurred during shipping.

Step 2

Find the right location
  • Decide where you want to install the sign. Consider visibility and proximity to a power source.
  • Ensure the surface is clean, dry, and flat.

Step 3

Marking and Drilling
  • Hold the sign against the wall in the desired position.
  • Mark the wall through the sign's mounting holes.
  • Drill holes where you marked.

Step 4

Inserting wall plugs into the drilled holes
  • Fix and screw stand-offs onto the wall

Step 5

Putting cushions on both sides of the backboard

Placing the silicon rings on both sides of the board through the screws

Step 6

Fixing the screw caps
  • Fix and tighten the screw caps

Step 7

Powering the sign
  • Carefully connect the sign to the dimmer and the power supply
  • Ensure all connections are secure and not strained
Maintenance and Troubleshooting

Maintenance:

  • Regularly dust the sign with a soft, dry cloth.
  • If needed, gently clean with a damp cloth and mild soap. Avoid harsh chemicals.

Troubleshooting:

  • If the sign does not light up, check the power supply and connections.
  • In case of flickering or partial illumination, ensure all connections are tight and secure.